Clore announces new battery charger to support diesel engine module reprogramming

Clore Automotive has introduced model PL6800, a 12-volt 100A flashing power supply and 100/40/10A battery charger from SOLAR.

Clore Automotive has introduced model PL6800, a 12-volt 100A flashing power supply and 100/40/10A battery charger from SOLAR.

The PL6800, according to Clore, is built to provide stable power on demand up to 100 amps to a vehicle electrical system to support module reprogramming. The unit is also capable of providing full-service battery charging from 10 to 100 amps. It is designed to work with vehicle batteries from small to the multi-battery packs found in over-the-road vehicles.

Per Clore, “In power supply mode, the PRO-LOGIX PL6800 provides power to maintain vehicle electrical system voltage at a preset level, increasing its output in response to system load increases to maintain a stable power environment for successfully reprogramming.”

The device is also designed for specified servicing.

According to Clore, “It features a voltage output range of 13.1-14.9V, adjustable in 0.1V increments. allowing the operator to dial the output in exactly as specified by the supplier of the vehicle under service. It features fast load responsiveness for ultra-quick recovery from system demand increases. It also delivers its massive power with minimal voltage ripple, providing a clean flow of power to the vehicle without risk of programming interference.”

While in its charging mode, the model uses advanced microprocessor-controlled logic to create a fully automatic charging routine optimized for charging and maintaining each battery it services.

The unit is capable of charging a variety of lead acid battery types.

According to Clore, “With a maximum charge rate of 100A, it can bring even severely depleted four-battery and eight-battery packs back to full charge quickly and effectively. The PL6800 adapts its charging approach based on the needs of each battery or battery pack it services.”